Which command is used for router configuration mode?
Which command is used for router configuration mode?
Entering and exiting in different modes:
| Modes | Access method | prompt |
|---|---|---|
| privilege mode | use enable command in user mode | router# |
| global configuration mode | use configure terminal command | router(config)# |
| Interface mode | use interface command and specify an interface in global configuration mode | router(config-if)# |
What is router basic?
A router is a networking device that forwards data packets between computer networks. Routers perform the traffic directing functions on the Internet. Then, using information in its routing table or routing policy, it directs the packet to the next network on its journey.
How many Cisco commands are there?
There are five command modes: global configuration mode, interface configuration mode, subinterface configuration mode, router configuration mode, and line configuration mode. After an EXEC session is established, commands within Cisco IOS Software are hierarchically structured.
What is the purpose of the show command in Cisco?
The show IP route command displays every known connected and destination network, the method used to learn about these networks, the next-hop IP address and the local interface used to get to each known destination network.
What is router CLI?
Most Cisco devices (including routers and switches) use a CLI (Command Line Interface) to configure the network device. The CLI is an interface, based on text. You type in configuration commands and use show commands to get the output from the router or switch.
What are the router modes?
There are four operating modes in the router settings — the main mode and three additional modes:
- Router (A) — main mode;
- Adapter (B) — connect Ethernet devices to a Wi-Fi network;
- Repeater/Extender (C) — Wi-Fi extension;
- Access point/Extender (D) — expansion of the Wi-Fi area with Ethernet connection.
How many modes does a Cisco router have?
There are five command modes: global configuration mode, interface configuration mode, subinterface configuration mode, router configuration mode, and line configuration mode….
| Router> | – User EXEC mode |
|---|---|
| Router# | – Privileged EXEC mode |
What are the parts of router?
Four components of a router can be identified:
- Input ports. The input port performs several functions.
- Switching fabric. The switching fabric connects the router’s input ports to its output ports.
- Output ports.
- Routing processor.
How do I setup a Cisco router?
Connect your computer to your router either via Wi-Fi or an Ethernet cable. Open a new Web browser tab, input the following IP address into the address bar and press Enter: Log in to your administration panel using your Cisco router’s administrative user name and password.
What is the Cisco command line?
Most Cisco devices (including routers and switches) use a CLI (Command Line Interface) to configure the network device. The CLI is an interface, based on text. You type in configuration commands and use show commands to get the output from the router or switch.
What is the configuration of a router?
Basic configuration of the router includes configuration of the IP address, default routing, static and dynamic routing, static and dynamic NATing, host name, banner, secret password, user accounts, and other options.