How do I pair my Scala G4?
How do I pair my Scala G4?
PAIRING THE G4 TO A BLUETOOTH MOBILE PHONE: Turn on your G4 by pressing the Mobile Button for at least four seconds resulting in three blue flashes. 2. With the G4 turned ON, press and hold the Mobile Button for at least six seconds until the Red and Blue Lights begin rapidly alternating.
Can Scala connect to Sena?
Apparently Sena has a Universal Intercom function to allow this. Tried it out yesterday and it worked like a charm. The way it works is like this. Both units are set up in pairing mode and the Scala rider recognizes the Sena as a phone.
How do I use Scala Rider?
Check the scala rider is in Standby (single BLUE flash every 3 seconds). 3. To pair Bluetooth Channel 1 – press for at least 5 seconds until the RED and BLUE LEDs begin rapidly alternating. To pair Bluetooth Channel 2 – press for at least 5 seconds until the RED and BLUE LEDs begin rapidly alternating.
How do you pair Cardo q3?
6.1 PAIRING BLUETOOTH CHANNELS 1 AND 2 Check the scala rider is in Standby. 3. To pair Bluetooth Channel 1 – press + for at least 5 seconds until the RED and BLUE LEDs begin rapidly alternating. To pair Bluetooth Channel 2 – press – for at least 5 seconds until the RED and BLUE LEDs begin rapidly alternating.
How do I pair Scala?
Check the scala rider is in Standby (single BLUE flash every 3 seconds). 3. To pair Bluetooth Channel 1 – press “V+” for at least 5 seconds until the RED and BLUE LEDs begin rapidly alternating. To pair Bluetooth Channel 2 – press “V-” for at least 5 seconds until the RED and BLUE LEDs begin rapidly alternating.
Is the Scala Rider G4 compatible with GPS?
The G4 connects with GPS units that feature a headset profile and Cardo Systems claims that the G4 is compatible with most major Bluetooth GPS devices. When connected to a GPS, the instructions from the unit will take priority over the FM radio and intercom conversations.
What kind of intercom does Scala rider have?
Continuing our foray into “3rd Generation” motorcycle intercom systems, we finally acquired a pair of the new Scala Rider G4 intercom, in the “Powerset” guise. The Powerset version is simply a paired pair; i.e., two G4 intercoms already paired at the factory.
Is the Sena SR10 compatible with the Cardo Scala Rider G4?
Non-interchangeable handlebar and clip mounts provided with the Sena SR10. After just under a minute from putting both devices into pairing mode, it appeared that the Cardo Scala Rider G4 (review) (running the version 3.0 firmware) wasn’t going to pair.
Where is the jack port on a Scala rider?
The jack port is located in back of the headset, rather than in the front or rear, so the right-angle 3.5 mm jack cable sticks out 14.5 mm from the back of the unit, placing it just about even with the back of the helmet mount. This may cause some interference with some helmets.