Is tonguing a word?
Is tonguing a word?
tongu•ing (tung′ing), n. [Music.] the manipulation of the tongue in playing a wind instrument to interrupt the tone and produce a staccato effect.
What’s tonguing mean?
Tonguing is a technique used with wind instruments to enunciate notes using the tongue on the palate or the reed or mouthpiece. For wind players, articulation is commonly spoken of in terms of tonguing because the tongue is used to stop and allow air to flow in the mouth.
What is tonguing in fishing?
1. tongue-fish – left-eyed marine flatfish whose tail tapers to a point; of little commercial value.
What is tonguing in sailing?
‘Tonguing’ refers to the tonguers, men who would cut up the whales on shore; they also often acted as intepreters with Māori communities, who also worked as part of the whaling crews.
Why is the Wellerman so popular?
Why are shanties suddenly so popular? “Wellerman,” the first to go viral, is extremely catchy. Shanties were sung as a way to get sailors to work together for the common good, even when they were stuck on small ships for years at a time, seeing the same few faces and hauling the same ropes every day.
What is no wind called in sailing?
Tide Over
What is three sheets to the wind mean?
To be “three sheets to the wind” is to be drunk. The sheet is the line that controls the sails on a ship. If the line is not secured, the sail flops in the wind, and the ship loses headway and control. If all three sails are loose, the ship is out of control.
What is the difference between tacking and jibing?
Tacking is how you head upwind, pointing as high into the wind as possible, to keep the sails full. A jibe is conducted when you are heading downwind. Both involve the processes of turning the boat to change course when the current direction of travel is no longer possible or safe.
What’s it called when a boat leans to the side?
That’s called ‘heeling’ when a sailboat leans to one side because the wind is blowing it over in a controlled fashion. Sailboats heel normally with the wind and depending on the angle of heel can actually go faster when on their side then if they were straight up.
What is it called when a boat is parked?
berth Add to list Share. But if you want to use berth as a verb, you better be talking about parking a boat: to berth means to moor or dock a ship. The parking spot itself also happens to be called a berth.
What is it called when a ship tilts?
“Listing” is a nautical term to describe when a vessel takes on water and tilts to one side. A ship can list either to port (left) or starboard (right). By contrast, a ship is said to be “trimming” when she tips forward or backward.
Why do bass boats lean to one side?
Unbalanced Load If your boat is leaning will at rest, this is often because of a weight distribution issue, either from storing gear or passengers more to one side then the other. Solution: Try moving your gear around and distribute the weight evenly, and store heavier items in the center of the ship.
Why is my boat leaning to the right?
Propeller Torque When going forward, the propeller turns clockwise. The torque from the rotation of the shaft causes the boat to turn and lean in the opposite direction – in this case, to the right. When the propeller is in reverse – that is, rotating counterclockwise – the boat may lean toward the right.
Why does my boat pull to the right?
Why The Boat Pulls To The Right Or Left That is mainly because of how the boat is pushed through the water by the propeller. The boat’s engine drives the propeller that spins in either a clockwise direction, (standard rotation) or a counter-clockwise direction, (left-hand rotation or counter-rotation).
Why is my boat pulling to the left?
Really? Just trim your drive to adjust steering torque. The higher it is in the water, the more it pulls left or port, the deeper it is in the water the harder it will pull right or starboard. You should be using the tilt/trim button as often as you are the throttle handle.
What pitch prop will make my boat faster?
A lower-pitch prop is like low gear in a car or a bicycle—you’ll accelerate quickly but top speed will suffer. A prop with too much pitch may deliver more top speed because the prop moves further forward with each rotation, but acceleration may be poor and the boat will struggle to get on plane.
Why is my boat steering so hard?
Not Enough Grease If your boat’s steering is unusually stiff, you should first check to make sure there’s adequate grease on the motor. Grease is necessary to keep the components moving and functioning as they are intended. Without this lubrication, the steering wheel may be difficult to turn.
How do you remove prop torque?
Engine Trim Running with the drive trimmed in exacerbates prop torque. Solution: It’s correct to trim the engine in when achieving plane. But up and running, trim out to lift the bow, and, as it pertains to listing and heeling, reduce the effect of prop torque.
How do you adjust the torque on a outboard tab?
Stop the boat to adjust the tab. Remove the plug on top of the anti-ventilation plate with the screwdriver to gain access to the trim tab bolt. Hold the trim tab firmly in position by hand and loosen the trim tab bolt. Rotate the tab in small increments in the appropriate direction, then firmly tighten the bolt.
What is the fin above the propeller called?
anode
What is torque steer on a boat?
Torque steer is the effect of the rotation of the propeller and the driveshaft being transmitted back to the steering wheel, and causing it to turn in the same direction as the prop’s rotation. Example: Bring the boat to a stop, then take your hands off the wheel and open up the throttle.
How do you compensate prop torque?
Prop torque is not countered by moving the rudder or by setting rudder trim. It is countered by moving or trimming the aileron. This correction induces adverse yaw, which is corrected by moving or trimming the rudder (right rudder).
What happens if outboard is too low?
An outboard that is mounted too low will limit your boat’s optimal operation. You can often tell that an outboard is too low if you are experiencing sluggish speeds, poor handling, excessive spray, porpoising, or even water pushing up into the cowling.
Do boats need torque?
In regards to boating, torque represents power in engines or the amount of work that can be done. Boats with more torque mean less time getting up to speed. Horsepower is power measured over time, which is what makes it different from torque.
How fast does a 7.5 hp outboard go?
A 7.5 should be around 10-12.
What is the biggest motor you can put on a 12 foot boat?
For example, a twelve-foot boat with a four-foot transom width translates into a maximum engine size of fifteen horsepower.
What size motor do I need for a 17 foot boat?
A small motor in the 7 to 10 hp range will usually have enough power to move a 17 ft runabout at hull speed, i e. not on plane. Many jurisdictions have reduced licensing requirements for boats under 10 hp. That is why 9.9 hp motors are very popular!
How much horsepower does a 16 foot boat need?
60 horsepower
How fast will a 5 hp outboard go?
limit of 6 knots. 5 is about the maximum rated power for the boat.
How fast will a 20 hp outboard go?
The Honwave 3.5ae with 20hp Tohatsu 4 stroke idles along in slack water at around 2 – 3 mph. Speed varies greatly upon tide / wind etc. Sometimes idle won’t push against the tide where I fish. 2 up the Tohatsu 20hp pushes the Honwave 3.5ae along at around 19 mph.